Worth Data 520-RF Specifications download pdf (Page 37)

Narda 37NBM-580

4.5Remotecommandsandinstructions

Commandabbreviations

Inthenextchapterallcommandsaredescribedinatable.

Somecolumnshaveaveryshortheaderwhichisnotself

explanatory.Thefollowingtabledescribestheseshort

headers:

S Belongs to a Setcommand

G Belongs to a Getcommand

R Belongs to the Response of a

getcommand

Inthenextchapter“Commands”thereisalsoinformation,

regardingparametersanddefaultvalues,included:The

factorydefaultsvaluesandthedefaultvaluesfornon-

persistent parameters are shown in “bold”inthecolumn

“Range”.

remote on;

DisconnectsHyperterminal.Thelocal/remotebuttonon

thefrontpanelisgreen.Hyperterminalcanreconnectto

the NBM-580 without pressing the front panel button�

remote off;

DisconnectsHyperterminal.Thelocal/remotebuttonturns

red.HyperterminalcannotreconnecttotheNBM-580until

thelocal/remotebuttonispressedandturnsgreen.

➩ Pressingthelocal/remotebuttonwhileitisgreenwill

disconnectwhateverisattachedtotheNBM-580(the

buttonwillashredandthenturngreen).

Welcomemessagewhenrstconnected:

“ConnectedtoNBM-580.Type“LIST_COMMANDS”forall

availableremotecmds.

Note:Allcommandsmustendinasemicolon.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 59 60

No comments

Worth Data 520-RF Specifications Page 37