17
Beep Tone
The default beep tone is 3 – Medium. Each time you press the “2” key you will hear a beep at various tones. When you
are happy with the tone of the beep, press 0 or F1 to exit.
Voice Volume
The default volume of the “Voice” is Medium. Unless you need very loud voice prompts you should use the medium set-
ting to conserve battery power. When you are happy with the loudness of the beep tone, press 0 or F1 to exit.
Keypad Tone
The “Keypad Tone” is the key click that you hear each time a key is pressed. Press the “4” key to toggle this On and Off.
Laser Options
Double Decode
Double Decode is there to minimize the possibility of misreads when scanning very poor quality bar codes. This option forces the RF
Terminal to keep reading until it gets two results that are identical. This "double scan checking" takes longer but will minimize mis-
reads since it must get the same result twice before considering it a "good" read.
4.5 Second Laser Beam
4.5-second laser beam increases the amount of time the laser beam is activated, giving the laser more time to try and read a code. This
option is useful for trying to read poor quality code. The default beam time is 2 seconds.
Aiming Dot Duration
Aiming Dot Duration (in 1/10 seconds)
This parameter applies to the built-in internal laser. Before the laser beam spreads, you can create a brighter aiming dot to be
sure you are on the bar code you want to read. The default is set to 00, no aiming dot. You can key in 01 through 99 which cre-
ates an aiming dot in 1/10th second increments; i.e., 20 would be two seconds.
This option is only available on the LT7101, LT7101H, LT7102, & LT7102H.
Filter Mode
This option is only available on the LT7111, LT7111H, LT7112, & LT7112H.
Comments to this Manuals