Worth Data 701 RF Owner's Manual download pdf (Page 9)

To change the internal battery:

1. Turn OFF the RF Terminal.

2. Remove the battery holder door on the back of the RF Terminal by removing the two screws holding the door in place..

3. Remove the old battery and insert a new one, making sure to orient the battery with the battery contacts facing the bat-

tery connector.

4. To replace the optional handle battery, remove the 2 screws holding the handle in place. Unplug the handle battery as-

sembly.

5. Replace the battery door and screws and turn the reader on using the ON/OFF switch.

6. Sign ON and resume your application.

Recharging the RF Terminal Battery:

1. With the RF Terminal shut off, plug the F17 power adapter into a wall outlet, and plug into the RF Terminal using the

supplied C25 Micro USB cable.

2. The RF Terminal will turn On and display the following message:

Charging Battery

Please Wait………..

3. When the battery is fully charged after 2-4 hours the following messaged is displayed:

Battery Charge Complete

4. The unit will remain ON for a half hour or so after the charge cycle has completed and then turn OFF.

5. If you press the POWER key while the unit is charging, nothing will happen.

6. If you press the POWER key after the unit has turned OFF after completing a charge cycle and the charger is still at-

tached, the “Charging Battery” message will display again and a charge cycle will begin.

7. It will take about 2 hours to fully charge a unit with a single battery and about 4 hours to fully charge a unit with the op-

tional handle battery.

8. Do not charge the battery if the Terminal is very hot or very cold since this will give a false reading on the condition of

the battery and it may not get charged properly.

9. You cannot operate the unit when the charger is attached, except to charge the battery.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 86 87

No comments

Worth Data 701 RF Owner's Manual Page 9